1 Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest and keyboard assembly.
2 Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
3 Adhere the tapes that secure the speaker cable to the palm-rest and keyboard assembly.
4 Connect the speaker cable to the system board.
5 Connect the touchpad cable to the system board and close the latch to secure the cable.
1 Install the battery.
2 Install the base cover.
3 Follow the procedure in After working inside your computer.
WLAN card
Removing the WLAN card
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
Removing and installing components
29
To Next Page
Loading...
