1 Connect the power-adapter port cable to the system board.
2 Replace the screw (M2x3) that secures the power-adapter port to the palm-rest and keyboard assembly.
3 Align and place the display-cable bracket on the system board.
4 Replace the screw (M2.5x3.5) that secure the display-cable bracket to the system board.
5 Using the alignment posts, close the display hinges.
6 Replace the screw (M2x4) that secure the right display hinge to the system board.
1 Install the battery.
2 Install the base cover.
3 Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
3 Remove the battery.
The following image indicates the location of display assembly and provides a visual representation of the removal procedure.
Removing and installing components
37
To Next Page
Loading...
