1 Remove the screw (M1.6x2) that secures the power-button bracket to the palm-rest and keyboard assembly.
2 Remove the screw (M1.6x2) that secures the power button with ngerprint reader to the palm-rest and keyboard assembly.
3 Open the latch and disconnect the ngerprint-reader cable from the ngerprint-reader board.
4 Lift the power button with ngerprint-reader, along with the power-button cable, o the palm-rest and keyboard assembly.
Installing the power button with ngerprint reader
NOTE
: This procedure is only applicable for computers shipped with a ngerprint reader.
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of power button with ngerprint reader and provides a visual representation of the installation
procedure.
46
Removing and installing components
To Next Page
Loading...
