1 Align and place the power button with ngerprint reader on the palm-rest and keyboard assembly.
2 Replace the screw (M1.6x2) that secure the power button with ngerprint reader to the palm-rest and keyboard assembly.
3 Connect the ngerprint-reader cable to the ngerprint-reader board and close the latch to secure the cable.
4 Align and place the power-button bracket on the palm-rest and keyboard assembly.
5 Replace the screw (M1.6x2) that secure the power-button bracket to the palm-rest and keyboard assembly.
1 Install the I/O board.
2 Install the fan.
3 Install the WLAN card.
4 Install the battery.
5 Install the base cover.
6 Follow the procedure in After working inside your computer.
System board
Removing the system board
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
3 Remove the battery.
4 Remove the M.2 2280 solid-state drive or M,2 2230 solid-state drive, whichever applicable.
5 Remove the WLAN card.
6 Remove the fan.
7 Remove the heat sink.
The following image indicates the location of system board and provides a visual representation of the removal procedure.
Removing and installing components
47
To Next Page
Loading...
