Installing the system board
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of system board and provides a visual representation of the installation procedure.
1 Slide the ports on the system board into the slots on the palm-rest and keyboard assembly and align the screw holes on the system
board with the screw holes on the palm-rest and keyboard assembly.
2 Connect the display cable on to the connector on the system board6
3 Connect the power-adapter port cable to the system board.
4 Connect the coin-cell battery cable to the system board.
5 Connect the keyboard backlit cable to the system board and close the latch to secure the cable.
6 Connect the keyboard cable to the system board and close the latch to secure the cable.
7 Connect the touchpad cable to the system board and close the latch to secure the cable.
8 Connect the ngerprint-reader cable to the system board and close the latch to secure the cable.
9 Connect the speaker cable to the system board.
Removing and installing components
49
To Next Page
Loading...
