1 Peel o the transparent protective lms from the SR tapes.
2 Align and adhere both the SR tapes to the plastic edge of the display back-cover.
3 Peel o the blue protective lms from the SR tapes.
4 Starting from the top, align and place the display panel on the display back-cover.
5 Remove the release paper from the pressure lm.
6 Adhere the pressure lm on the display panel.
7 Using the at end of the plastic scribe or handle of the screwdriver, press and roll over the pressure lms until they turn pink.
8 Peel o the pressure lm from the display panel.
9 Place the display bezel on the display back-cover and snap it into place.
1 Install the display bezel.
56
Removing and installing components
To Next Page
Loading...
