Dell Latitude 3301 - Camera

If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of display hinges and provides a visual representation of the installation procedure.
1 Align the screw holes on the hinges with the screw holes on the display back-cover.
2 Replace the two (M2x2) screws that secure the display hinges to the display back-cover.
3 Replace the four (M2.5x2.5) screws to secure the display hinges to the display back-cover.
1 Install the display bezel.
2 Install the display assembly.
3 Install the WLAN card.
4 Install the battery.
5 Install the base cover.
6 Follow the procedure in After working inside your computer.
Camera
Removing the camera
NOTE
: This procedure is not applicable to computers shipped with a WWAN conguration.
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
3 Remove the battery.
4 Remove the WLAN card.
5 Remove the display assembly.
6 Remove the display bezel.
7 Remove the display panel.
58
Removing and installing components