Installing the display cable
NOTE: This procedure is not applicable to computers shipped with a WWAN conguration.
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of display cable and provides a visual representation of the installation procedure.
1 Adhere the tape securing the display cable to the back-cover.
2 Adhere the display cable to the display back-cover.
1 Install the display bezel.
2 Install the display panel.
3 Install the display assembly.
4 Install the battery.
5 Install the base cover.
6 Follow the procedure in After working inside your computer.
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
3 Remove the battery.
4 Remove the WLAN card.
Removing and installing components
63
To Next Page
Loading...
