Removing the battery
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. microSD card
b. base cover
3. Peel off the tape [1] and disconnect the battery cable from the system board [2].
4. Peel off the piece of tape [3] on the memory module bracket and unroute the battery cable.
5.
Remove the single M2.0x3.0 screw [1] and the two M2.0x3.0 screws [3].
NOTE:
This procedure shows a 3-cell 42 WHr battery removal. The 4-cell 56 WHr battery is slightly bigger in size and
attaches to the palmrest.
6. Separate the battery support bracket [4] from the palmrest and Lift the battery away from the computer [2].
20
Disassembly and reassembly
To Next Page
Loading...
