3. Reconnect the battery cable to the connector on the system board.
4. Install the:
a. base cover
b. microSD card
5. Follow the procedure in After working inside your computer.
Solid state drive (SSD)
Removing the SSD
1.
NOTE:
This system has the option to fit two form factors (M.2 2242 and M.2 2230) SSD/eMMC cards. This is achieved
by removing, inverting, and installing the extender to an alternate location as marked on the palmrest.
Follow the procedure in Before working inside your computer.
2. Remove the:
a. microSD card
b. base cover
3. Disconnect the battery cable from the connector on the system board.
4. Remove the single M2.0x4.0 screw along with the washer that secures the SSD on the extender [1].
5. Remove the SSD from the M.2 slot on the system board [2].
Disassembly and reassembly
27
To Next Page
Loading...
