Figure 2. M.2 2230 SSD
2. Reconnect the battery cable to the connector on the system board.
3. Install the:
a. base cover
b. microSD card
4. Follow the procedure in After working inside your computer.
SSD bracket
Removing the SSD bracket
1.
NOTE:
This system has the option to fit two form factors (M.2 2242 and M.2 2230) SSD/eMMC cards. This is achieved
by removing, inverting, and installing the extender to an alternate location as marked on the palmrest.
Follow the procedure in Before working inside your computer.
2. Remove the :
a. microSD card
b. base cover
3. Disconnect the battery cable from the connector on the system board.
4. Remove the SSD
5. Remove the two M2.0x3.0 screws securing the SSD bracket to the palmrest [1].
6. Remove the SSD bracket from the palmrest [2].
Disassembly and reassembly
29
To Next Page
Loading...
