Steps
1. Use the pull tab to disconnect the battery cable from the connector system board.
2. Remove the three screws (M2x3) that secure the 3-cell battery to the palm-rest and keyboard assembly.
3. Lift the 3-cell battery, along with the battery cable, at an angle. Slide out the 3-cell battery to remove it from the palm-rest
and keyboard assembly.
4. Disconnect and remove the battery cable from the 3-cell battery.
Installing the 3-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the 3-cell battery and provide a visual representation of the installation procedure.
20
Removing and installing components
To Next Page
Loading...
