5. Connect the touchpad flexible flat cable and keyboard flexible printed circuits to the connector on the system board and
close the latch.
Next steps
1. Install the wireless card.
2. Install the 3-cell battery or the 4-cell battery, whichever applicable.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
Touchpad
Removing the touchpad
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the 3-cell battery or the 4-cell battery, whichever applicable.
4. Remove the speakers.
About this task
The following images indicate the location of the touchpad and provide a visual representation of the removal procedure.
Steps
1. Open the latch and disconnect the touchpad cable from the connector on the system board.
Removing and installing components
53
To Next Page
Loading...
