Next steps
1. Install the speakers.
2. Install the 3-cell battery or the 4-cell battery, whichever applicable.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
System board
Removing the system board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the 3-cell battery or the 4-cell battery, whichever applicable.
4. Remove the M.2 2230 solid-state drive or the M.2 2280 solid-state drive, whichever applicable.
5. Remove the wireless card.
6. Remove the thermal fan.
7. Remove the thermal heat-sink.
8. Remove the display assembly.
About this task
The following image indicates the connectors on your system board.
Figure 1. System-board connectors
1.
Speaker cable connector 2. Thermal fan cable connector
Removing and installing components 55
To Next Page
Loading...
