Steps
1. Remove the two screws (M2x3) that secure the display-cable bracket to the system board.
2. Remove the display-cable bracket from the system board.
3. Remove the two screws (M2x3) that secure the right display hinge to the system board.
4. Lift the right display hinge in upward direction away from the system board.
5. Remove the screw (M2x3) that secures the USB type-C bracket to the system board.
6. Lift and remove the USB type-C bracket from the system board.
7. Disconnect the following cables from the respective connectors on the system board:
a. Touchpad FFC
b. I/O board cable
c. Speaker cable
d. Coin-cell battery cable
e. Power adapter port cable
f. Keyboard cable
g. Keyboard backlit LED cable, if applicable
NOTE: This step applies only to systems shipped with a keyboard backlight installed.
8. Remove the four screws (M2x2) that secure the system board to the palm-rest and keyboard assembly.
9. Lift and remove the system board from the palm-rest and keyboard assembly.
Installing the system board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the connectors on your system board.
Removing and installing components
57
To Next Page
Loading...
