Steps
1. Remove the two screws (M2x3) that secure the right display hinge to the system.
2. Lift the right display hinge in upward direction away from the system.
3. Remove the screw (M2x3) that secures the USB type-C bracket to the system board.
4. Lift and remove the USB type-C bracket from the system board.
5. Disconnect the power-adapter port cable from the connector on the system board and remove the power-adapter port from
the system board.
Installing the power-adapter port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the power-adapter port and provide a visual representation of the installation
procedure.
62
Removing and installing components
To Next Page
Loading...
