Steps
1. Align and place the power-adapter port on the system board.
2. Connect the power-adapter port cable to the connector on the system board.
3. Align and place the USB type-C bracket on the system board.
4. Align the screw holes on the USB type-C bracket with the screw holes on the system board.
5. Replace the screw (M2x3) to secure the USB type-C bracket to the system board.
6. Gently press the right display hinge in downward direction towards the system.
7. Align the screw holes on the right display hinge with the screw holes on the system.
8. Replace the two screws (M2x3) to secure the right display hinge to the system.
Next steps
1. Install the system board.
NOTE:
The system board can be installed with the thermal heat-sink attached to it in order to simplify the procedure
and preserve the thermal bond between the system board and the thermal heat-sink.
2. Install the thermal heat-sink.
3. Install the thermal fan.
4. Install the wireless card.
5. Install the M.2 2230 solid-state drive or the M.2 2280 solid-state drive, whichever applicable.
6. Install the 3-cell battery or the 4-cell battery, whichever applicable.
Removing and installing components
63
To Next Page
Loading...
