Installing The Power Connector
1. Replace the power connector port into its compartment.
2. Tighten the screw to secure the power connector port in place.
3. Install:
a) system board
b) display assembly
c) palmrest
d) memory
e) hard drive
f) keyboard
g) base cover
h) decure digital (SD) card
i) battery
4. Follow the procedures in
After Working Inside Your Computer
.
System Setup Options
NOTE: Depending on your computer and its installed devices, the items listed in this section may or may not
appear.
Table 1. General
Option Description
System Information This section lists the primary hardware
features of your computer.
• System Information
• Memory Information
• Processor Information
• Device Information
Battery Information Displays the charge status of the battery.
Boot Sequence Allows you to change the order in which the
computer attempts to find an operating
system. All the below options are selected.
• Diskette Drive
• Internal HDD
27
To Next Page
Loading...
