Installing the audio connector board
1. Place the audio connector board into the slot on the computer.
2. Tighten the screw to secure the audio connector board to the computer.
3. Connect the audio connector board cable to the system board.
4. Install the:
a. base cover
b. battery
5. Follow the procedure in After working inside your computer.
Removing the hard drive
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. base cover
3. To remove the hard drive:
a. Remove the screws that secure the hard drive to the computer.
b. Slide the hard drive to disconnect it from the connector on the system board.
c. Lift the hard drive from the computer.
Installing the hard drive
1. Align the hard drive on with the slot on the computer.
2. Slide the hard drive into the connector on the system board.
3. Tighten the screws to secure the hard drive to the computer.
4. Install the:
16
To Next Page
Loading...
