Installing the display assembly
1. Align the palmrest assembly with the display assembly.
2. Tighten the screws to secure the display hinges to the palmrest assembly.
3. Connect the following cables:
a. touch panel
b. network connector
c. display
4. Align the bracket over the display cable and tighten the screw to secure the bracket to the computer.
5. Connect the antenna cables to the WLAN card and route them along the channels on the computer.
6. Install the:
a. base cover
b. battery
7. Follow the procedure in After working inside your computer.
Removing the system board
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. SD card
b. battery
c. SIM card
d. base cover
e. memory module
f. keyboard trim
g. keyboard
h. coin cell battery
i. audio connector board
25
To Next Page
Loading...
