Table 8. Power Management
Option Description
AC Behavior Allows the computer to power on automatically, when AC adapter is
plugged. The option is disabled.
• Wake on AC
Auto On Time Allows you to set the time at which the computer must turn on
automatically. The options are:
• Disabled (Default Setting)
• Every Day
• Weekdays
• Select Days
USB Wake Support Allows you to enable the USB devices to wake the computer from standby
mode. The option is disabled.
• Enable USB Wake Support
Wireless Radio Control Allows you to control the WLAN and WWAN radio. The options are:
• Control WLAN radio
• Control WWAN radio
Default Setting: both the options are disabled.
Wake on LAN/WLAN This option allows the computer to power up from the off state when
triggered by a special LAN signal. Wake-up from the Standby state is
unaffected by this setting and must be enabled in the operating system. This
feature only works when the computer is connected to AC power supply.
• Disabled – Does not allow the system to power on by special LAN
signals when it receives a wake-up signal from the LAN or wireless LAN.
(Default Setting)
• LAN Only - Allows the system to be powered on by special LAN signals.
• WLAN Only
• LAN or WLAN
• LAN with PXE Boot
Block Sleep Allows you to block the computer from entering into the sleep state. Option
is disabled by default.
• Block Sleep (S3)
Peak Shift Peak Shift minimizes AC power usage at times of peak demand. Option is
disabled by default.
Advance Battery Charge
Configuration
Advanced Battery Charge minimizes battery health while still supporting
heavy use during the work day. Option is disabled by default.
Primary Battery Charge
Configuration
Allows you to change the battery charge configuration.
• Adaptive (Default setting)
• Standard
• ExpressCharge
• Primarily AC Use
• Custom
35
To Next Page
Loading...
