Dell Latitude 3380 - Installing Heat Sink

a microSD card
b base cover
c battery
3 To remove the heatsink:
a Loosen the captive screws (M2.5x2.5) that secure the heat sink to the computer [1].
NOTE: Follow the diagonal pattern to loosen the screws.
b Lift the heat sink away from the computer [5].
Installing heat sink
1 Insert the heat sink into the slot on the computer.
2 Tighten the M2.5x2.5 screws to secure the heat sink to the computer.
NOTE
: Follow the diagonal pattern to tighten the screws, similar to the pattern followed to loosen the screws in
"Removing heat sink".
3 Install the:
a battery
b base cover
c microSD card
4 Follow the procedure in After working inside your computer.
18
Removing and installing components