Installing the power button board with optional fingerprint reader
Steps
1. Place the power-button board into the slot on the palmrest and keyboard assembly [1].
2. Replace the single (M2x3) screw that secures the power button board to the palmrest and keyboard assembly [2].
3. Affix the conductive tape to the power button board [1].
4. Affix the power button cable to the palmrest and keyboard assembly [2].
5. Slide the power button cable and fingerprint reader cable to the system board and close the latch to secure the cable [3].
Removing and installing components
77
To Next Page
Loading...
