Dell Latitude 3410 - Installing the Heatsink Assembly - Discrete; Removing the Heatsink Assembly - UMA

Steps
1. Remove the single (M2x3) screw that secures the solid-state module to the palmrest assembly.
2. Slide the solid-state module out from the M.2 slot.
Installing M.2 2230 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the installation
procedure.
Disassembly and reassembly
35