3. Disconnect the WLAN antenna cables, and remove the cables from the cable management routes along side the fan
assembly.
4. Remove the two (M2x2) screws from the fan assembly and lift the fan assembly away from the computer.
Installing the Fan Assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the fan assembly and provides a visual representation of the installation procedure.
Steps
1. Place the fan assembly onto the mounting points on the palmrest on the computer and install the two (M2x2) screws.
2. Route the antenna cables along the cable management routes on the fan assembly and connect the cables to the WLAN
card.
3. Install the two (M2x2) screws onto the fan assembly and secure it in place.
4. Route the IO board cable along the cable management route on the fan assembly and connect it to the system board.
44
Disassembly and reassembly
To Next Page
Loading...
