About this task
The following image indicates the location of the display bezel and provides a visual representation of the installation procedure.
Steps
NOTE:
While installing the replacement display bezel for the models that are shipped with a camera, carefully peel off the
piece of tape that is used to secure the camera shutter to the replacement display bezel.
CAUTION: You must take extra care when peeling the tape. An abrupt peeling may remove the camera shutter
from the display bezel and damage the camera shutter.
1. Align and place the display bezel on the display assembly.
2. Gently snap the display bezel into place.
Next steps
1. Install the display assembly.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Display panel
Removing the display panel
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the display assembly.
4. Remove the display bezel.
60
Removing and installing components
To Next Page
Loading...
