About this task
NOTE: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
The following images indicate the location of the M.2 2230 solid-state drive and provides a visual representation of the
installation procedure.
Figure 10. Installing the M.2 2230 solid-state drive
Steps
1. Align the notch on the M.2 2230 solid-state drive with the tab on the solid-state drive slot.
2. Slide the M.2 2230 solid-state drive into the M.2 2230 solid-state drive slot on the system board.
3. Align the tab on the thermal shield with the recess on the system board.
4. Replace the screw (M2x3) that secures the solid-state drive thermal shield to the solid-state drive.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing and installing Customer Replaceable Units (CRUs)
37
To Next Page
Loading...
