Table 25. Antenna-cable color scheme(continued)
Connectors on the
wireless card
Antenna-cable color Silkscreen marking
Auxiliary Black AUX ▲ (black triangle)
2. Align the notch on the wireless card with the tab on the wireless-card slot on the system board.
3. Slide and insert the wireless card at an angle into the wireless-card slot on the system board.
4. Place the wireless-card bracket on the wireless card.
5. Replace the screw (M2x3) that secures the wireless card and wireless-card bracket to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Fan
Removing the fan
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following image(s) indicate the location of the fan and provides a visual representation of the removal procedure.
Figure 13. Removing the fan
Steps
1. Disconnect the fan cable from the connector on the system board.
2. Remove the two screws (M2x3) that secure the fan to the palm-rest and keyboard assembly.
40
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
