Figure 17. Removing the battery cable
Steps
1. Disconnect the battery cable from the connector on the system board (if not disconnected earlier).
2. Remove the battery cable from the routing guides on the battery.
3. When disconnecting the battery cable from the battery, you must first unlock the connector on the battery by sliding the
latch on the connector outwards.
Figure 18. Disconnecting the battery cable
After unlocking the latch, unthread the battery cable and then pull the battery cable connector at a diagonal angle to remove
it from the battery.
Removing and installing Field Replaceable Units (FRUs)
45
To Next Page
Loading...
