Figure 27. Removing the speakers
Steps
1. Disconnect the fingerprint reader cable (for computers shipped with fingerprint reader), touchpad cable, keyboard cable, and
keyboard backlight cable (for computers shipped with keyboard backlight) from the system board.
2. Disconnect the speaker cable from the system board.
3. Peel the tapes that secure the speaker cable to the palm-rest and keyboard assembly.
4. Remove the speaker cable from the routing guides on the palm-rest and keyboard assembly.
5. Lift the right and left speakers, along with its cable, off the palm-rest assembly.
Installing the speakers
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
Removing and installing Field Replaceable Units (FRUs)
53
To Next Page
Loading...
