4. Lift and remove the left hinge from the display back cover.
Installing the display hinges
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the display hinges and provide a visual representation of the installation procedure.
Figure 36. Installing the display hinges
Steps
1. Align the screw hole on the left hinge with the screw hole on the display back cover.
2. Replace the three screws (M2.5x3.8) that secure the left hinge to the display back cover.
3. Align the screw hole on the right hinge with the screw hole on the display back cover.
4. Replace the three screws (M2.5x3.8) that secure the right hinge to the display back cover.
Next steps
1. Install the display bezel.
2. Install the display assembly.
3. Install the wireless card.
4. Install the base cover.
5. Follow the procedure in After working inside your computer.
62
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
