Figure 41. Installing the display panel
Steps
1. Connect the display cable to the connector on the display panel and close the latch to secure the cable.
2. Adhere the tape that secures the display cable to the display panel.
3. Close the display panel and the display back cover to assemble.
NOTE: Ensure that the display panel tabs are inserted into the slots on the display cover.
4. Replace the two screws (M2x2) that secure the display panel to the display back cover.
Next steps
1. Install the display hinges.
2. Install the display bezel.
3. Install the display assembly.
4. Install the wireless card.
5. Install the base cover.
6. Follow the procedure in After working inside your computer.
System board
Removing the system board
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the M.2 2230 solid-state drive.
4. Remove the wireless card.
66
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
