Installing the system board
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the system board connectors.
Figure 44. System board connectors
1.
Display cable connector 2. Keyboard-backlight cable connector (for computers shipped
with keyboard backlight)
3. Keyboard cable connector 4. Battery cable connector
5. Touchpad cable connector 6. Fan cable connector
7. Solid-state drive slot 8. Fingerprint-reader cable connector (for computers shipped
with a fingerprint reader)
9. Wireless-card slot 10. Speaker cable connector
The following images indicate the location of the system board and provide a visual representation of the installation procedure.
Removing and installing Field Replaceable Units (FRUs)
69
To Next Page
Loading...
