Steps
1. Carefully pry up the camera module from the recesses at the bottom edge of the camera module.
Figure 47. Removing the camera module
2. Peel the tape that is covering the display cable connector.
3. Disconnect the display cable from the camera and lift the camera module from the display back cover.
Installing the camera module
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the camera module and provide a visual representation of the installation
procedure.
72
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
