Figure 46. Installing the palm-rest and keyboard assembly
Steps
Place the palm-rest and keyboard assembly on a flat surface.
Next steps
1. Install the power-adapter port.
2. Install the system board.
NOTE:
The system board can be installed with the thermal heat-sink attached to it in order to simplify the procedure
and preserve the thermal bond between the system board and the thermal heat-sink.
3. Install the touchpad.
4. Install the speakers.
5. Install the power button .
6. Install the I/O board.
7. Install the display assembly.
8. Install the coin-cell battery.
9. Install the heat-sink.
10. Install the fan.
11. Install the wireless card.
12. Install the M.2 2230 solid-state drive
13. Install the battery.
14. Install the base cover.
15. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
78
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
