Passos seguintes
1. Volte a colocar a tampa da base
2. Volte a colocar a placa de memória SD
3. Siga o procedimento indicado em Após efetuar qualquer procedimento no interior do computador
Disco rígido
Removing the hard drive assembly
Prerequisites
1. Follow the procedure in before working inside your computer
2. Remove the SD memory card
3. Remove the base cover
4. Disconnect the battery cable.
Steps
1. Disconnect the hard drive cable from the system board [1].
2. Peel the tape that secures the hard drive cable to the palmrest and keyboard assembly [2].
3. Remove the four (M2x4) screws that secure the hard drive assembly to the palmrest and keyboard assembly [1].
4. Lift the hard drive from the slot on the palmrest and keyboard assembly [2].
24
Retirar e instalar componentes
To Next Page
Loading...
