About this task
The following images indicate the location of the system board and provide a visual representation of the installation procedure.
CAUTION: The system has a coin-cell battery that is connected to the I/O board. Disconnecting the I/O
board cable resets the BIOS setup program settings to default. Note the BIOS setup program settings before
disconnecting the I/O board cable.
Steps
1. Align and place the system board on the palm-rest and keyboard assembly.
2. Align the screw holes on the system board with the screw holes on the palm-rest and keyboard assembly.
3. Replace the four screws (M2x3) to secure the system board to the palm-rest and keyboard assembly.
4. Connect the following cables to the respective connectors on the system board:
a. Touchpad cable
b. I/O board cable
c. Speaker cable
d. Thermal fan cable
e. Display cable
f. Power adapter port cable
50
Removing and installing components
To Next Page
Loading...
