Installing the battery
1. Insert the battery into the slot on the tablet.
2. Replace the M2.0 x 4.0 screws to secure the battery to the tablet.
3. Install the:
a. display panel
b. uSIM/microSD card
NOTE: uSIM card is installed only on tablets shipping with WWAN module.
4. Follow the procedure in After working inside your tablet.
System fan
Removing the system fan
1. Follow the procedure in Before working inside your tablet.
2. Remove the:
a. uSIM/microSD card
NOTE: Micro-SIM card slot is available only on tablets shipped with WWAN module.
b. Display panel
3. To remove the system fan:
a. Disconnect the system fan cable from the system board [1].
b. Remove the M2.0 x 4.0 screws that secure the system fan [2].
c. Lift the system fan from the tablet [3].
Using your tablet
25
To Next Page
Loading...
