f SSD with holder
g SSD frame
h WLAN card
i WWAN card (optional)
3 To release the chassis frame:
a Release the WLAN and WWAN cables from the routing channels [1].
b Disconnect the speaker cable from the connector on the system board [2].
c Unroute the cable from the routing channel.
d Lift the latch and disconnect the keyboard backlight cable and the keyboard cable from the connector [3, 4] on the system.
NOTE: There may be more than one cable to disconnect based on the keyboard type.
4 To remove the chassis frame:
a Remove the 2 (M2x3) screws, 3 (M2x5) screws and the 2 (M2x2) screws that secure the chassis frame to the system [1].
b Lift the chassis frame away from the system [2].
26
Removing and installing components
To Next Page
Loading...
