Steps
1. Align and place the sensor board on the display back cover.
2. Connect the display cable to the connector on the sensor board and close the latch.
Next steps
1. Install the display panel.
2. Install the display bezel.
3. Install the display assembly.
4. Install the 3-cell battery or 4-cell battery.
5. Install the base cover.
6. Follow the procedure in after working inside your computer.
LED board
Removing the LED board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the 3-cell battery or 4-cell battery.
About this task
The following image indicates the location of the LED board and provides a visual representation of the removal procedure.
Removing and installing components
107
To Next Page
Loading...
