Steps
1. Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest assembly.
2. Route the speaker cable through the routing guides on the palm-rest assembly.
3. Adhere the tape to secure the speaker cables.
4. Connect the speaker cable to its connector on the system board.
5. Connect the USH board cable, LED cable, and touchpad cable to its connectors on the system board.
Next steps
1. Install the 3-cell battery or 4-cell battery.
2. Install the base cover.
3. Follow the procedure in after working inside your computer.
Fan
Removing the fan
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the 3-cell battery or 4-cell battery.
4. Remove the WLAN card.
About this task
The following images indicate the location of the fan and provide a visual representation of the removal procedure.
44
Removing and installing components
To Next Page
Loading...
