Steps
1. Adhere the coin-cell battery to the slot on the palm-rest assembly.
2. Route the coin-cell battery cable through the routing guides on the palm-rest assembly.
3. Connect the coin-cell battery cable to the connector on the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in after working inside your computer.
Keyboard assembly
Removing the keyboard assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the 3-cell battery or 4-cell battery.
4. Remove the WLAN card.
5. Remove the WWAN card (optional).
6. Remove the M.2 2280 SSD or M.2 2230 SSD.
7. Remove the fan.
8. Remove the system board.
62
Removing and installing components
To Next Page
Loading...
