Installing the WWAN card
About this task
CAUTION:
To avoid damage to the WWAN card, do not place any cables under it.
Steps
1. Insert the WWAN card into the connector on the system board [1].
2. Connect the WWAN antenna cables to the connectors on the WWAN card [2].
3. Place the WWAN card bracket to secure the WWAN antenna cables to the WWAN card [3].
4. Replace the single (M2x3) screw to secure the WWAN card bracket to the WWAN card [4].
Onderdelen verwijderen en plaatsen
25
To Next Page
Loading...
