Next steps
1. Install the Inner frame.
2. Install the coin cell battery.
3. Install the DC-in.
4. Install the memory module.
5. Install the WLAN.
6. Install the WWAN.
7. Install the battery.
8. Install the base cover.
9. Install the microSD card.
10. Follow the procedure in After working on your computer.
Moederbord
Removing the system board
Prerequisites
1. Follow the procedure in before working with your computer.
2. Remove the microSD card.
3. Remove the base cover.
4. Remove the battery.
5. Remove the WWAN.
6. Remove the WLAN.
7. Remove the memory module.
8. Remove the DC-in port.
Onderdelen verwijderen en plaatsen
61
To Next Page
Loading...
