Steps
1. Locate the SSD slot on your computer.
2. Slide the SSD into the slot.
3. Place the SSD thermal tape over the SSD module.
4. Replace the single (M2x3) screw to secure the SSD module to the computer.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The figure indicates the location of the coin-cell and provides a visual representation of the removal procedure.
Steps
1. Locate the coin-cell battery on your computer.
2. Disconnect the coin-cell battery cable from the connector on the system board.
3. Lift the coin-cell battery out of the computer.
32
Disassembly and reassembly