Steps
1. Align and place the inner frame into the slot on your computer.
2. Replace the six (M2x5) and six (M2x3) screws to secure the inner frame to the computer.
3. Route the WWAN and WLAN antenna cables through the retention clips on the frame.
4. Adhere the coin-cell battery to the inner frame.
Next steps
1. Install the WLAN card.
2. Install the WWAN card.
3. Install the 2280 SATA SSD.
4. Install the battery.
5. Install the base cover.
6. Follow the procedure in After working inside your computer.
Heatsink assembly-discrete
Removing the heatsink assembly-discrete
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the inner frame.
About this task
The figure indicates the location of the Heatsink and provides a visual representation of the removal procedure.
36
Disassembly and reassembly
To Next Page
Loading...
