2. Remove the base cover.
3. Remove the battery.
4. Remove the display assembly.
5. Remove the display bezel.
6. Remove the display hinge caps.
7. Remove the display hinges.
8. Remove the display panel.
9. Remove the camera.
10. Remove the display cable.
About this task
After performing the preceding steps, you are left with the display back cover.
Next steps
1. Install the display cable.
2. Install the camera.
3. Install the display panel.
4. Install the display hinges.
5. Install the display hinge caps.
6. Install the display bezel.
7. Install the display assembly.
8. Install the battery.
9. Install the base cover.
10. Follow the procedure in After working inside your computer.
Palmrest assembly
Replacing the palmrest assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
Disassembly and reassembly
89
To Next Page
Loading...
