Table 4. General (continued)
Option Description
Boot Sequence Allows you to specify the order in which the computer attempts to find an operating system
from the devices specified in this list.
UEFI Boot Path Security This option controls whether or not the system will prompt the user to enter the Admin
password when booting a UEFI boot path from the F12 Boot Menu.
● Always, Except Internal HDD—Default
● Always, Except Internal HDD&PXE
● Always
● Never
Date/Time Allows you to set the date and time settings. Changes to the system date and time take
effect immediately.
.
System information
Table 5. System Configuration
Option Description
Integrated NIC Allows you to configure the on-board LAN controller.
● Disabled = The internal LAN is off and not visible to the operating system.
● Enabled = The internal LAN is enabled.
● Enabled w/PXE = The internal LAN is enabled (with PXE boot) (selected by default)
SATA Operation Allows you to configure the operating mode of the integrated hard drive controller.
● Disabled = The SATA controllers are hidden
● AHCI = SATA is configured for AHCI mode
● RAID ON = SATA is configured to support RAID mode (selected by default)
Drives Allows you to enable or disable the various drives on-board:
● SATA-2 (enabled by default)
● M.2 PCIe SSD-0 (enabled by default)
Smart Reporting This field controls whether hard drive errors for integrated drives are reported during system
startup. The Enable Smart Reporting option is disabled by default.
USB Configuration Allows you to enable or disable the integrated USB controller for:
● Enable USB Boot Support
● Enable External USB Port
All the options are enabled by default.
Thunderbolt Adapter
Configuration
This section allows Thunderbolt Adapter Configuration.
● Thunderbolt-is enabled by default
● Enable Thunderbolt Boot Support-is disabled
● No security-is disabled
● User configuration-enabled by default
● Secure connect-is disabled
● Display port and USB Only-is disabled
USB PowerShare
This option configures the USB PowerShare feature behavior.
● Enable USB PowerShare - disabled by default
This feature is intended to allow users to power or charge external devices, such as
phones and portable music players, using the stored system battery power through the USN
PowerShare port on the notebook, while the notebook is in a sleep state.
118 System setup
To Next Page
Loading...
