Steps
1. Locate the WLAN card slot on your computer.
2. Slide the WLAN card into the slot on the system board.
3. Connect the WLAN antenna cables to the WLAN module.
4. Place the WLAN card bracket on the WLAN card and replace the single (M2x3) screw to secure the bracket to the computer.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
WWAN card
Removing the WWAN card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
20
Disassembly and reassembly