Steps
1. Unroute the WWAN and WLAN antenna cables from the routing clips.
2. Peel the coin-cell battery from the inner frame.
3. Remove the six (M2x5) and six (M2x3) screws that secure the inner frame to the computer.
4. Lift the inner frame out of the computer.
Installing the inner frame
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the inner frame and provides a visual representation of the installation procedure.
Disassembly and reassembly
27
To Next Page
Loading...
